Multistar 2206-2150KV 3~4S 320w FPV Racing Motor "The Baby Beast" (AR Warehouse)
Looking for the ultimate power system for your next Multi-rotor project? Look no further!
The Turnigy Multistar outrunners are designed with one thing in mind - maximizing Multi-rotor performance! They feature high-end magnets, high quality bearings and high pole counts for less noise, smooth, responsive power and increased efficiency. They have custom motor mounting, and all are precision balanced for smooth running, these motors are engineered specifically for multi-rotor use and are not based on airplane motors.
The 2206-2150KV Multistar nicknamed the “Baby Beast”, is the monster motor for the small 250 class Quadcopters! Designed for 5 or 6 inch 4 blade props, this motor has power on tap, and ready for your fully loaded 250. The motor has been beefed up in all the right places for FPV durability, with 3.17mm center shaft, 11mm prop flange and a 5mm prop shaft, there is no need to worry about the occasional tree in the way. It’s fitted with shimmed and pre-loaded bearings and high-grade silicon wires. If you’re looking for more power, durability and value for your sub-300mm multirotor, think…. Multistar 2206 the Baby Beast
Multistar is simplifying the world of Multi-Rotors with their purpose built product line and taking the guess work out of your setup.
*Note: lower mounting screw length is critical to check. The lowered housing was reduced in height to make a nice compact 2206, the tradeoff is the motor winding is closer to the bottom, so overly long mounting screws could potentially contact the windings and damage the motor.
Prop Type Thrust Amps
4 Blade 5040 851grams 18.32amps
Lipo cells: 3~4s
Max Power: 320w
Max Amps: 18A
Dimensions(Dia.xL): 27 x 17mm
Motor Shaft: 3.17mm (5mm prop shaft)
Prop shaft: 5mm
Bolt hole spacing: 16mm * 19mm
Connectors: 2mm bullet