Turnigy DLG Butterfly/V-tail Multi-Mixer

Описание

Discus launch gliders are a lot of fun, but if you have a basic transmitter you are missing out on an important feature, camber control. The Turnigy DLG Multi-Mixer does just that. This handy dandy little doo dad, allows you to have your aileron control, and use the throttle stick as camber control. Doing so allows you to change the ailerons from neutral, reflexed, or drooped depending on the lift conditions. Maybe the wind has died, you want to run a lot of camber to get the best lift, then the wind picks up, bring up the ailerons to clean up the airframe for better wind penetration. Additionally, if you need it for Rudder/Elevator ship, the Turnigy DLG Multi-Mixer has a built in V-tail mode to mix rudder and elevator inputs properly.

To install when using the camber mode, simply plug in your two aileron servos into the unit, then plug the unit into the aileron and throttle channels. After setting your servo reversing you should be ready to use the ailerons as flaps.

Features:
• Camber control and V-tail modes
• Simple setup
• Small and light weight

Specs:
Dimensions: 30x11x5.5mm (not including wires)
Weight: 3g