Gas Engine CDI Ignition Test and Timing Setup Tool - Includes Crankshaft Degree Wheel (AR Warehouse)

Описание

This is a fantastic tool for those of us using gas powered engines in our models!

Anyone who uses gas powered CDI ignition engines should have this tool.

This tester can be used in two ways:

1. It enables the safest possible way to check for interferance between your CDI Ignition and radio systems, without the need to have your engine running. The unit fires your ignition system at the rpm you set on the units dial to simulate the ignition as if the motor is running, the units RPM range is 400-18000Rpm.

2. The unit can also be used to set up a Gas engines static base timing, included is a crankshaft degree wheel to assist with this task. In this mode the test unit emits a beep at the point where the the ignition sensor (Hall sensor) is interrupted and using the degree wheel you can calculate this back to degress before top dead center (BTDC) of your engines piston stroke, allowing you to fine tune your engine for maximum performance.

Take the guess work out of your Gas engines ignition timing and add safety to RF interferance testing!