Student 64E Intermediate Trainer 1200mm (ARF) (AR Warehouse)

Описание

The Student 64E is a tough and brilliant performing sport/aerobatic model that tamed down can make a good trainer or livened up will be fun for even the most experienced flyers. It has amazing performance and is great for flying in small areas as its low aspect ratio symmetrical wing is great for slow flying but when the power is on and with plenty of control travel it can be thrown around all over the sky, only held back by the ability of the pilot.The Student 64E has been developed around the popular 3S 2100 - 2500 size Lipo packs but for extreme flying there is also plenty of room for a 4s, the battery hatch is easily accessible underneath and is held in place with strong rare earth magnets so no need to remove the wings for battery changes.

The construction of the Student 64E is a strong, lightweight balsa and ply structure which is finished in a lightweight but tough covering material, it requires a minimum of work to get it ready for the flying field. Just join the wings, glue on the tail sections, bolt on the pre-formed dural undercarriage (this will enable you to fit props up to a massive 14ins and still have ample ground clearance), then all that has to be done is fit the motor, ESC, servos and radio. The motor mount is a very strong plywood box and is ready to accept any of the popular 35mm diameter brushless outrunner motors, it also has pre-drilled holes and pre-fitted blind nuts for easy mounting of your chosen motor.

Features:
• Great for beginners and experienced flyers
• Wide speed range
• Amazing low speed handling
• Factory built and covered
• Balsa and ply construction
• Tall strong dural undercarriage
• Pre-painted fiberglass cowl
• Comprehensive hardware pack

Specs:
Wingspan: 1200mm
Length: 1020mm
Wing Area: 29.5dm²
Weight: 1250g (RTF without battery)

Required:
Transmitter and Receiver
4 x 20~25g servo (30 x 15mm)
35-36 or 35-42 brushless outrunner
2100~2500 3s or 4s Lipoly
1 x Y lead and 2 x 400mm ext leads
or
2 x 600mm ext leads (if you wish to mix flaperons)
Prop to suit motor choice
30 min epoxy