Diatone MAMBA F722S + F50 PRO ESC 50A 6S Blheli_32

MAMBA F722S APP I2C WIFI F50PRO 3-6S Flight Controller Stack

Firmware Target /Config： Mamba F722 I2C

Diagram Link From Help Centre Link

Note：Since STM32F722 heat large ， please leave at least 5mm interspace at both sides of the FC with nothing covered to make sure a good air circulation.

Update Details:

BT to WiFi
USB power supply can use receiver, OSD
Add a group of I2C pads (SCL SDA)
Add inverter Dual-Way TX serial port
Add 2812 LED switch function, key can turn off led
Add 4 corner LED interface to support BF led and Mamba led
Upgrade to stronger type-C, optimize pad position

FC Specifications

MCU: 216MHz STM32F722RET6 32BIT
IMU: MPU6000
Barometer: No
OSD: BF OSD
Blacbox: 16M Flash Memory
Uarts: 6Set
ESC Soft: Dshot300/600/1200
ESC Telemetry: RX6
LED indicator: Blue&Orange for FC Status,Green 9V,White 5V,Red 3.3V

LED Controller:BF LED/MB LED（ 4 Set 2812 LED）
WIFI: SpeedyBee APP
Smartaudio: Yes
Buzz: Yes
Input: 3~6S Lipo (12.6~25V)
TVS Protection: Yes
BEC: 5V 2.5A & 9V 2A (Max 3A)
MOUNTING: 30.5mm/M3 WEIGHT: 9g
Supply :
8pin sh1.0 *1

Smartaudio: Yes
Buzz: Yes

Input: 3~6S Lipo (12.6~25V)
VTS Protection: Yes

ESC Specifications

F50PRO

INPUT VOLTAGE: 3~6S Lipo (12.6V~25V)

CONTINUE CURRENT: 50A×4

BURST CURRENT: 60A (10S)

BEC: NO

ESC Dshot300/600/1200

MOUNTING: 30.5mm/M3

Supply : Panasonic High Frequency 470uF/35V

Mounting: 30.5×30.5mm,Φ3
Dimensions:
Weight: 22g

Including
1× MAMBA F722 APP <WIFI> F50PRO

About SpeedyBee Function：

For WIFI

For BlueTooth