Flywoo Goku GN 405S AIO 20A + HM850 850mw VTX

FLYWOO new top GOKU series AIO are finally here! GOKU GN405 20A FC is an economical and durable all-in-one AIO , which can meet most your FPV needs.
Use powerful F405 chip , integrate 5V BEC, barometer, black box, WS2812LED, support 6 complete hardware serial ports, I2C and other functions are all open.

Features

• F405 BGA MCU
• Barometer
• 5V BEC
• Black Box
• 20A 8Bit ESC
• 6 UARTS
• current sensor
• LED

Specifications
\GN 405S 20A AIO Flight Controller

• MCU: STM32F405 BGA 8bit processor
  
• IMU: MPU6000 (SPI)
  
• Barometer: BMP280
  
• Onboard LED：WS2812*4
  
• 6 hardware UARTS (UART1,2,3,4,5,6)
  
• Supports serial receivers (SBUS, iBus, Spektrum, Crossfire) only.
  
• PPM and PWM receivers are not supported.
  
• Onbord 8Mbytes for Blackbox logging
  
• 5V Power Out: 2.0A max
  
• 3.3V Power Out: 0.5A max
  
• Dimensions: 33.5x33.5mm
  Mounting Holes: Standard 25.5/26.5mm square to center of holes
  Weight: 8.5g
  
  
• Support BLHELI_S
  Support PWM, Oneshot125, Oneshot42, Multishot, Dshot150, Dshot300, Dshot600
• Input Voltage: 2-6S Lipo
• Continuous Current: 20A
• Firmware: BLHELI_S

HM850 850mw vtx

• Input Voltage: +7-28V Input
  
• Channels: 40CH
  
• Power: PIT/25/50/100/200/850mw
  
• Microphone: Built-in high quality AGC mic
  
• Antenna: IPX / UFL
  
• Size: 30.5mm×3.5mm×3mm
  
• Weight: 3g
• Control Mode:IRC(RX)/Button
  
• Raceband: 5362-5945 MHZ

Q&A :
1、 Betaflight Firmware target: FLYWOOF405S_AIO
2、INAV Firmware target: FLYWOOF405S_AIO
3、GOKU GN405S 20A AIO Wiring Diagram : ( LINK )
4、GOKU HM850 VTX TABLE，The same as HM600 TABLE : （LINK）
5、GOKU HM850 VTX instruction : ( LINK )