* The red LED indicates the state of working mode or the item when setting the VTX(flashing 1 time means selecting the channels, flashing 2 times means selecting the bands).

* The blue LED indicates the state of Pitmode or the value of item when setting the VTX ( e.g. when selecting the channels, 1 times of flashing means channel 3. When selecting the bands, 1 times of flashing means band A.)

* The green LED flashing indicates that the VTX overheat protection is working, the power level will go down.

2. Working mode indication

* After powering up, the red & blue LEDs will signal the following two items of VTX in turn: channel, band (the flashing times of the red and blue LEDs indicate the item and the value respectively). After that, the LEDs indicate the working modes.

* Normal: The red & blue LED are on.

* Pitmode:The red LED is on and blue LED is off.

3. Setting

* The red LED flash 1 time which means the item of channel selecting, then press the button can select the channels(blue LED flashing times corresponds to the channel 1-8).

* The red LED will flash 2 times which means the item of band selecting, then press the button can select the band(blue LED flashing times corresponds to the band A-F).

For e7082VM, Betaflight/Cleanflight OSD setting of channel,band and Pitmode ,please referring to 'Betaflight OSD setting of EWRF Transmitter' for details.

EWRF e7082VM 5.8G 40CH 100mW Power Adjustable FPV Transmitter W/ Betaflight Cleanflight OSD

Frequency (Mhz)

Band	CH1	CH2	CH3	CH4	CH 5	CH6	CH7	CH8
A	5865	5845	5825	5805	5785	5765	5745	5725
b	5733	5752	5771	5790	5809	5828	5847	5866
c	5705	5685	5665	5645	5885	5905	5925	5945
d	5740	5760	5780	5800	5820	5840	5860	5880
E	5658	5695	5732	5769	5806	5843	5880	5917

Note:
1. Make sure that there is enough space for airflow when installing the module on the drone in case the overheating protection starts to reduce the power even to shut down at the worst.
2. Please install the antenna before powering up for a longer use life.